Error code · Styler

LG Styler Code E1: Steam Heater Sensor

E1 on an LG Styler steam closet is listed as a Steam Heater Sensor Error. The sensor belongs to the steam system, which produces the steam used in refresh cycles. When the closet cannot read it…

Medium · inspection needed

(713) 597-5662

Code: E1
Appliance: Styler
Brand: LG
Warranty: 30-day workmanship

What E1 means

E1 on an LG Styler steam closet is listed as a Steam Heater Sensor Error. The sensor belongs to the steam system, which produces the steam used in refresh cycles. When the closet cannot read it normally, steam cycles may not start or may stop early, and E1 stays on the display. The S3RFBN and the other Styler models use the same list, and the next step is repair service.

Common causes of E1

The sensor reading on the steam heater
The wiring and plug between that sensor and the control
The control board input for the sensor
Mineral buildup near the steam heater area

✓ One safe check you can try

1. Note that E1 is showing and which cycle you were using. 2. Check that the water dispenser holds only clean water and that the drain tray is not overfilled. 3. Skip steam cycles until we have looked at it. 4. Call us to schedule a visit, since E1 needs a technician.

! Why to stop there

The sensor is hidden inside the closet, so we test its reading directly to see whether the sensor, its wiring or the board is behind it.
If E1 comes with E4, the heater itself may be involved, and we check both together.
The price is written before we start, and the repair has a 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Styler codes

tE1LG Styler Code tE1: Duct Out Thermistor tE2LG Styler Code tE2: Compressor Thermistor tE3LG Styler Code tE3: Duct In Thermistor tE4LG Styler Code tE4: Steam Thermistor tE5LG Styler Code tE5: Evaporator In Thermistor AELG Styler Code AE: Compressor Alignment CLLG Styler Code CL: Control Lock or Touch Not Read dELG Styler Code dE: Door Not Fully Closed

E1E1 questions

What does E1 mean on a Styler?

The list calls it a Steam Heater Sensor Error. The closet cannot get a normal reading from the sensor tied to its steam heater, so steam cycles can be blocked until it is repaired.

Can I still use non-steam cycles with E1?

The display may keep E1 up and steam cycles can be blocked. We suggest holding off on cycles until it is checked, so you do not repeat the error.

Is E1 something I can reset?

E1 calls for repair service. Switching the closet on and off will not fix a sensor problem, so we test the sensor, its wiring and the board input to find the source.

Book a visit

Still seeing E1?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 597-5662